[. . . ] When reinstalling the chassis and its assemblies, be sure to restore all protective devices, including : control knobs and compartment covers. Make sure that there are no cabinet openings through which people--particularly children --might insert fingers and contact dangerous voltages. Such openings include the spacing between the picture tube and the cabinet mask, excessively wide cabinet ventilation slots, and improperly fitted back covers. 2 megohms, an abnormality exists that must be corrected before the unit is returned to the customer. [. . . ] 6) Adjust the ÒFF (DATA UP)/REW (DATA DOWN)Ó button so that the blue level is 350mVp-p ± 50mV. 7) Be sure to press the ÒSTART/STOP (CONFIRM)Ó button to memorize setting. 4) Press the ÒSTILL (MODE UP)/DISPLAY (MODE DOWN)Ó button so that the OSD state is Ò38 CBGN XX XXÓ. 5) Aim the camera at a color bar chart illuminated at 1500 to 2000 lx. 6) Adjust the ÒFF (DATA UP)/REW (DATA DOWN)Ó button so that the yellow level is 350mV. 7) Be sure to press the ÒSTART/STOP (CONFIRM)Ó button to memorize setting. 4) Press the ÒSTILL (MODE UP)/DISPLAY (MODE DOWN)Ó button so that the OSD state is Ò39 CHGR XX XXÓ. 5) Aim the camera at a color bar chart illuminated at 1500 to 2000 lx. 6) Adjust the ÒFF (DATA UP)/REW (DATA DOWN)Ó button so that the cyan vector is 284. 7) Be sure to press the ÒSTART/STOP (CONFIRM)Ó button to memorize setting. 4) Press the ÒSTILL (MODE UP)/DISPLAY (MODE DOWN)Ó button so that the OSD state is Ò79 CBHN XX XXÓ. 5) Aim the camera at a color bar chart illuminated at 1500 to 2000 lx. 6) Adjust the ÒFF (DATA UP)/REW (DATA DOWN)Ó button so that the red vector is 104. 7) Be sure to press the ÒSTART/STOP (CONFIRM)Ó button to memorize setting. 4) Press the ÒSTILL (MODE UP)/DISPLAY (MODE DOWN)Ó button so that the OSD state is Ò35 CHYE XX XXÓ. 5) Aim the camera at a color bar chart illuminated at 1500 to 2000 lx. 6) Adjust the ÒFF (DATA UP)/REW (DATA DOWN)Ó button so that the yellow vector is 165. 7) Be sure to press the ÒSTART/STOP (CONFIRM)Ó button to memorize setting. 4) Press the ÒSTILL (MODE UP)/DISPLAY (MODE DOWN)Ó button so that the OSD state is Ò36 CHB XX XXÓ. 5) Aim the camera at a color bar chart illuminated at 1500 to 2000 lx. 6) Adjust the ÒFF (DATA UP)/REW (DATA DOWN)Ó button so that the blue vector is 346. 7) Be sure to press the ÒSTART/STOP (CONFIRM)Ó button to memorize setting. [. . . ] Com manuals search engine Block Diagrams 8-10 Camera Main/CCD Samsung Electronics 8-11 Downloaded from www. Com manuals search engine PCB Diagrams 9-1 Main (Component Side) 9-2 Samsung Electronics Downloaded from www. Com manuals search engine PCB Diagrams (Conductor Side) Samsung Electronics 9-3 Downloaded from www. Com manuals search engine PCB Diagrams 9-2 Rear (Component Side) 9-4 (Conductor Side) Samsung Electronics Downloaded from www. [. . . ]